How to solve the vibration of stainless steel plate with abrasive belt

Sanding belt grinding stainless steel plate is how to solve the vibration. If it is a sand-belt problem, the solution is as follows:

1. Replace the interface of the belt with S joints, and never use partical top-skived.

2, S joints also want to connect flat, or it will cause tremors

3, The sand size of the sand belt is not uniform, the solution: change the sand belt with more uniform gravel.

4. If it is oil drawing, it is recommended to use silicon carbide sand belt

5, The sand belt can not appear bell mouth, treatment: before installing the sand belt, the two ends of the sand belt alignment, if there is no crease in the middle of the line

In general, when the new belt starts to use, there will be a few boards will appear tremors, after a few grinding boards will be better.